Energy Storage Science and Technology ›› 2020, Vol. 9 ›› Issue (6): 1982-1990.doi: 10.19799/j.cnki.2095-4239.2020.0103

• Energy Storage Test: Methods and Evaluation • Previous Articles     Next Articles

DC-side modeling of the modular multilevel battery energy storage system based on carrier phase shift modulation

Kai TIAN1(), Kun CHEN1, Man CHEN2, Zhibin LING1()   

  1. 1.Key Laboratory of Control of Power Transmission and Conversion, Shanghai Jiao Tong University, Shanghai 200240, China
    2.Technology Center of CSG Power Generation Company, Guangzhou 511400, Guangdong, China
  • Received:2020-03-01 Revised:2020-05-26 Online:2020-11-05 Published:2020-10-28

Abstract:

The carrier phase shift pulse width modulation (CPS-PWM) is a modulation method widely used in modular multilevel converter-based battery energy storage systems (MMC-BESS). At present, the mathematical modeling of MMC-BESS based on CPS-PWM is mostly concentrated on the AC side of the system, and its analysis of the output voltage waveforms is mostly focused on the frequency domain. The mathematical modeling for the DC side of the system and the time-domain analysis of the output waveforms has not yet been studied. Moreover, the instantaneous equivalent circuit for the DC side of MMC-BESS is still unclear. This study performs a theoretical research on CPS-PWM and the DC side of MMC-BESS. Accordingly, time-domain triangle wave mathematical expressions for the carrier waveforms are established, including the two most commonly used CPS-PWM (i.e., N + 1 and 2N+1 modulations). The intersection point sequence is proposed for a constant modulation wave and the carrier waveforms in a carrier period. The expressions of the intersection time interval and the number of sub-modules opened in a single phase, which are only related to the modulation ratio and the number of sub-modules in an arm, are then obtained. Based on this, an equivalent model of the DC side of MMC-BESS is established. We find that the DC side of the system can be equivalent to two voltage sources and one switch, and its parameters are only related to the modulation ratio and the number of bridge modules. Subsequently, the ripple expression of the DC current in the equivalent switching cycle is calculated based on this model. A method for determining the bridge inductance, which can meet the design requirements for the DC current ripple in the steady state, is also proposed. Finally, a three-phase 48-module MMC-BESS simulation model is built in MATLAB/Simulink. The simulation results of important system parameters, such as the number of open sub-modules, equivalent switching frequency and duty cycle, and DC current ripple, are consistent with the theory, thereby verifying the mathematical model accuracy. The simulation results of the current ripple can meet the design requirements when the method for choosing the bridge inductance is used. This also confirms the method effectiveness.

Key words: modular multilevel battery energy storage system(MMC-BESS), carrier phase shift pulse width modulation(CPS-PWM), DC-side equivalent model, bridge inductance

CLC Number: